Pumps are an important component in many agriculture-based industries. To ensure the best results, it’s important to measure the pump’s performance in different areas. While there are many different types of pumps for sale in the market, most pumps work in a similar manner.
In this blog post, we’ll go over three ways to measure a pump’s performance.
Using Manometer
A manometer can be used to measure a pump’s performance by measuring changes in pressure and converting them into watts or any other unit used to measure horsepower. These readings work best if you’re trying to check the pump’s thumping power or water flow rate. However, you may still require someone with knowledge and expertise to overlook the process.
Flow Rate
Flow rate measures how much water a single gallon of water will fill up in 12 hours, assuming 100% efficiency. The pump’s flow rate will vary depending on the distance to be covered. For instance, you can determine this by measuring the time it takes for 1 gallon of water to travel 100 feet and multiplying this by 60 (minutes).
If a 16-gallon/min submersible pump takes 1 minute to travel 100 feet, then it will do 16 gallons in 1 hour. Based on these figures, it can pump 960 gallons in 12 hours. Once you get the results, you can decide if the pump suits your purpose.
Head Pressure
A head pressure measures the pressure developed when the water drops vertically from one level to another. In other words, it is a measurement of the power developed when pumping water at a given height.
Efficiency
Efficiency refers to how well your pump works and how much power it uses per unit of work. When an electric motor is used to create a small amount of work, it will use more power than its efficiency rating. If the motor were to use only 80% of its maximum rated capacity and push the same amount of water through a pump, it will be considered more efficient.
We have highlighted some of the ways you can analyze the efficiency of your pump. However, keep in mind that a pump’s performance is also affected by certain environmental conditions, such as temperature and water characteristics. If you’re not happy with your pump’s performance, then consider getting it inspected or replaced by professionals.
At Contact Instruments, we provide industry-standard pump impellers, trash pump parts, torque gauges and systems, and other hydraulic solutions. We are currently operational across different areas of Alberta, Canada. We have 90 years of experience in the industry and take pride in being one of the most reliable companies in the industry. Give us a call to find out more.